There are times when all the settings on Low and high end valves just doesn’t work.
Well this video will show you what to do and how to fix the trouble making carburetor of your RC Nitro Vehicle.
Enjoy and don’t forget to watch it. There is a teaser run at the end too 
Video Rating: 4 / 5
Is that a HIMOTO Cyclone???
@linkinpark345123 you can go with aluminum one
Hey Ali what do u recommend aluminum clutch shoes or the black carbon ones?
Thanks
That is a nice rc you got there
very fast lol
dude, save the blowing for the bedroom
lol
i love that car : )
@shaddyforth its all your choice my man
@halomoviesweet settings can differ from engine to engine, you need to find your engine specific settings so keep the experimentation going till you set it up
hey alishanmao i know u say to flush low ende to the edge of the tyrannosaurus carb but mine is in from this point about 1 turn…. if it is flush it loads up with fuel and then dies when throttle is applied… i tried changing glow plug but it still did this i am running a hot glow plug with 20% nitro fuel….. is this normal does my engine just behave different with others…..
what is better on road or off road
ok thanks mate
@icey221 Just bolt it in and tune it
i just got a brand new carb do i need to run it in or break it in or is it just bolt it on and away you go?
are those explosions in the backround?
@italianboy5555 Exhaust should be on the engine using a plastic pipe and Zip tie. Just pull it out.
hey my pull start just broke and im buying a power start and i am still a begginer and when i tried to unscrew the screws to the engine they wouldnt budge so i stopper=d i did not want to strip them and then i saw the bolts on the top so i think i can figure that out but then how do i take the engine awayt from the exuast.. i have a redcat tornado BB witn none of the upgrades… help plzzz
@BBbullet96 if you are driving in dirt often, or muddy tracks, dirt track, then you should do this often
does this problem happen alot
@alishanmao Could have i tighten it to much…?
Is that a possibility?
Thanks in advance….
@Nickjo1000 you have fixed something wrong inside there. take the heat sink or engine head apart and fix parts again.
Hi i’ve got a problem with my rc car i i am thinking if anyone can help me please….
I’ve got a HSP 1/10th scale nitro rc car with a .18vx engine i recently changed the engine head(it was from a same engine). Anyway when i tried to start it it was very dificult to pull the pull start(i also tried it without the fuel line but the same thing happened) and i was wondering if u could help me….
Thanks in Advance!!!
@flightboom12 you must have set the idle speed screw wrong. reset it and carb will lock nicely
@flightboom12 There is a screw and a nut under it on the engine crank shaft case. Loosen them n carb can come out
how do you take the carb out
How do i fix my buggy if the idle needle is in but the carb opening is lose and can come out of the whole carburetter system. how to i secure it back in?